You’re setting up the KryoZon S9 Water Cooling Phone Cooler for a gaming session and need to choose High, Low or AI before the first match. Its fanless cooling head uses water circulation and semiconductor TEC cooling, so the useful first step is to install the head and submerged pump correctly—not to assume that a mode’s name predicts your phone’s result. The official S9 product page confirms the three mode names and the cooling design.
Key Takeaways
- The three S9 mode names do not establish performance differences for your game.
- The pump must remain fully submerged while the cooler operates.
- The inline button switches the unit off after a 2-second hold.
- A personal comparison works best with labeled readings and similar game conditions.
The S9 water-cooling setup begins with a submerged pump
The printed S9/S11 operating guide says to put the pump completely under water before use, in a large-capacity container of room-temperature water. It also says the pump must remain fully submerged while operating and prohibits running it dry. Prepare that part of the setup before attaching the cooling head or starting a game; a mode comparison is not useful if the basic operating arrangement changes between attempts.
Find a stable place for the water container where you can reach the inline controller without pulling on the tubing. The S9 product specifications list a 1.2 m tube length. Arrange the tube so your normal hand movements do not drag the container or shift the head on the phone.
The S9 offers magnetic and clip attachment and is listed for phones up to 92 mm wide on the official product page. Choose the supplied attachment method that suits your phone and check that the head sits securely before play. If you use a case, look at the actual fit rather than assuming the cooler will make the same contact through every case. A desk-mounted phone is another option: the S9 has a 1/4-inch brass thread listed for most streaming stands and tripods.
Power information deserves a quick check before the session. The S9 specification lists Type-C input and 12 V / 2.5 A for the unit; the printed operating guide separately recommends a compatible 12 V / 3 A fast-charging power source. These are different statements—one is the listed device specification and the other is a source recommendation. Check your available supply against the instructions rather than guessing from a charger’s connector alone.
The S9 controller has a documented start and stop sequence
Once the pump is submerged and the cooling head is fixed to the phone, press the inline controller button to start cooling. To turn the unit off, hold that button for 2 seconds. Those are the start and stop actions given in the printed operating guide.
That documented button press should not be mistaken for a published High-to-Low-to-AI switching sequence. The supplied instructions establish how to start and stop the S9, but do not establish a specific gesture for moving among those three options. Look at the labels and controls on the unit in front of you and consult the manual supplied with your own cooler when changing settings. Avoid relying on a guessed series of taps while a match is underway; first confirm which option the device actually shows.
High, Low and AI name options, not guaranteed results
The official S9 specification names three modes: High, Low and AI, but does not give a mode-by-mode phone-temperature result, noise measurement or gaming-performance figure. The listing gives a 30 W power specification, not a separate wattage for each mode.
| Option to identify | What you can establish now | What to check during your game |
|---|---|---|
| High | It is a named S9 mode. | Record how your particular session feels and behaves with the displayed option selected. |
| Low | It is a named S9 mode. | Repeat the same game and setup, then note any difference you actually observe. |
| AI | It is a named S9 mode. | Note the displayed option and your experience without assuming an undocumented automatic rule. |
The S9 product listing names High, Low and AI. The checks in the table are a personal comparison method. You might care most about a comfortable grip, an unobstructed screen, how the setup sits on a stand or the way your game behaves late in a session.
Sound is worth judging at the position where you actually play or record, not from a mode name. The manufacturer’s specification describes a fanless cooling head and rates the pump below 30 dB. That is a manufacturer pump rating, not a microphone measurement for each setting or a guarantee about what your recording will capture. If game audio or voice chat matters, listen to a short recording made with your usual microphone placement before settling on a preferred setup.
The S9 temperature display needs a named reading source

The S9 has a real-time temperature display, according to the official product specification. Write down what that display shows if you find it useful, but label it as an S9 display reading. Do not silently combine it with a game launcher’s phone-temperature value or call it the processor or battery temperature. Different readouts are only useful together when you can tell which device or app supplied each one.
In r/Realme, a commenter reported that their phone game launcher showed around 43°; they questioned its accuracy. That phone reading is not an S9 measurement. Source: Reddit r/Realme
For your own notes, give each number a source: “S9 display,” “phone game launcher,” or the name of another readout you used. Add the option shown on the controller and what was happening in the game when you looked. If you cannot reliably view a phone reading during play, skip it; observations about grip, game behavior and your preferred layout still help you choose a repeatable setting.
A matched gaming session makes the choice personal
Compare one option at a time using a game you actually play. Keep the phone, attachment, desk position, water-container arrangement and game settings as similar as practical. Begin each attempt with the pump fully submerged, as required by the operating guide. Choose a point you can recognize in each session—such as the same game activity—rather than comparing one quiet menu with a demanding match.
- Write down the game and the phone you are using, along with any settings you intend to keep unchanged.
- Note the mode label that your S9 actually shows. If you cannot identify it confidently, resolve that before treating the attempt as a comparison.
- Record an S9 display value only with its source clearly named. Keep any phone-app reading in a separate field.
- Note what you care about in play: grip, screen access, apparent game behavior, microphone pickup or the convenience of the physical setup.
- Try another available option in a similar session, then compare your notes rather than your expectation of what High, Low or AI ought to mean.
If the phone was charging in one session and not another, or the game activity changed substantially, mark that difference in your notes. Keep the displayed label with your notes so you can identify what you actually compared.
A repeatable S9 routine is more useful than a favorite label alone
Put the pump fully under room-temperature water, fit the cooling head, arrange the 1.2 m tubing without tugging on your playing position, and start cooling with the inline button. The water and button steps are documented in the operating guide; the tube length appears in the S9 specifications. Confirm the displayed option rather than assuming the controller retained a previous selection.
If you stream or record, include your stand position and microphone placement in that routine. The S9 specification describes a fanless cooling head and gives the pump a manufacturer noise rating below 30 dB; your own recording is the practical check for your room and microphone. If you play handheld, note which attachment leaves your fingers and screen controls comfortable.
Keep the printed operating instructions handy for the submerged-pump rule and the 2-second shutoff. For the listed modes, attachments and power specifications, check the KryoZon S9 product page.
Product Specifications
| Model | Cooling | Power | Noise | Weight | Attachment | Port | Voltage | Mount | Modes | Material | Package | Fits | Display | Protection | Tube Length |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| KryoZon S9 Water Cooling Phone Cooler - Fanless Liquid Cooling | Water circulation + semiconductor TEC | 30W | Fanless cooling head; pump <30dB (manufacturer rating) | 75g (cooling end only) | Magnetic + Clip | Type-C | 12V / 2.5A | 1/4" brass thread (most streaming stands/tripods) | 3 modes: High / Low / AI | Aluminum Alloy + ABS | Cooler, cable, clip, manual | Phones up to 92mm wide | Real-time temperature | Overheat alert + auto shutoff | 1.2m |
Frequently Asked Questions
Which KryoZon S9 mode is best for gaming?
There is no verified all-games winner among High, Low and AI in the supplied S9 specifications. Try the options shown on your unit with the same game and a similar setup, then choose according to the observations that matter to you.
Does S9 AI mode switch at a particular temperature?
The official S9 specification lists AI as a mode but does not establish a switching threshold or describe its control logic. Do not use an assumed threshold to interpret the controller display; check the instructions supplied with your unit for any additional operating detail.
How do I turn the KryoZon S9 on and off?
First fully submerge the pump in room-temperature water and fix the cooling head to the phone. The printed operating guide says to press the inline controller button to start cooling and hold it for 2 seconds to switch the product off.
Is the S9 display showing my phone’s battery temperature?
The product specification confirms a real-time temperature display but does not identify its value as a battery-temperature reading. Label it “S9 display” in your notes and record any phone-app measurement separately.
References & Citations
- The shared S9/S11 operating instructions require a fully submerged pump, describe fitting the cooling head and pressing the inline button to start, and specify a 2-second hold to shut off. (Printed S9/S11 operating guide)
- A poster reported a game-launcher reading of approximately 43° and expressed uncertainty about its accuracy. (Reddit r/Realme thread)
Community & User Sources
- We're at minus 9 right now... Let's drop some water and see if it will freeze... It is just now ice. (TrueEasyTech (Influencer))
- Best loop score 7023; Lowest loop score 6271; Stability 89.3%; Battery 100% to 77%; Temperature 26 C to 41 C. (TrueEasyTech (Influencer))
- Water cooler: 7023 best, 6271 lowest, 89.3% stability. Earlier RedMagic result: 8033 best, 6477 lowest, 80.6% stability. (TrueEasyTech (Influencer))